6GHz RF Over Fiber


      6.0GHz RF Over Fiber

RF Optic 6.0GHz RF Over Fiber

RF Optic’s palm size analog RFoF modules support up to 6.0 GHz to convert RF signals to optical signals to carry over long distances. The Tx unit uses an optical transmitter to convert RF to optical signal. The Rx unit converts it back to RF signal. The two units are connected through the customer’s single mode fiber.

RF Optic Key Features
  • Next generation RFoF modules with significant performances improvement.
  • Supports up to 0.5 MGz – 6.0 GHz.
  • Better linearity, excellent gain flatness, and Tx, Rx and link gain control.
  • Noise Figure down to 6 dB with LNA with MDS ~168 dB/Hz for very low incoming signals.
  • Internal micro-controller and optical control enabled by software.
  • End-to-end diagnostics reduce installation and maintenance time, enabled by software.
  • Gain variation S21(fo) of ±1 dB for 90 °C variation, using special algorithms.
  • Remote management by GUI installed on PC.
  • Impedances of 50 Ohm and 75 Ohm.

RF Optic Configurations
  • Bias-T for GPS applications
  • Outdoor enclosure (unidirectional/bidirectional)
  • 1U generic enclosure (4 units)
  • 1U removable panel enclosure (4/8 units)

RF Optic Applications

Jason Lin,
2018年12月3日 凌晨1:25