|
IT-100 Multisystem TV Signal Analyze
PLANAR IT-12 DVB-S/S2 SIGNAL ANALYZER
IT-100 TV signals multisystem analyzer is designed to measure signals parameters of digital and analog television. The analyzer can be used when checking and servicing cable coaxial, fiber-optic or IP networks for receiving television and radio broadcasting, separate elements of network building and other radio electronic devices.
Measuring TV signals parameters: - Analog television: support for PAL, SECAM, NTSC standards.
Measured parameters: Level, Video/Audio, Carrier/Noise (inband and outband of video signal), modulation depth, unwanted modulation level (HUM), CSO&CTB distortion components level. - Cable digital television: support for DVB-C, ITU-T J.83 Annex B, C standards.
Measured parameters: power, MER, BER, constellation diagram, error analysis over time. - Terrestrial digital TV broadcasting: support for DVB-T, DVB-T2 standards.
Measured parameters: power, MER, BER, constellation diagram, echo diagram, error analysis over time. - Satellite broadcasting digital television: support for DVB-S, DVB-S2 standards.
Measured parameters: power, MER, BER, constellation diagram, error analysis over time. - IP digital television: support for UDP and RTP protocol, reception of the Transport Stream through unicast and multicast (IGMPv2).
Measured parameters: average bitrate, number of lost packets (for RTP), jitter of packets arrival interval.
Additional features of the IT-100 analyzer:- Monitoring of TV picture and audio:
- Monitoring of PAL, SECAM, NTSC analog channels
- Monitoring of radio FM stations
- Monitoring of digital channels with MPEG-1, MPEG-2, MPEG-4, H.264 encoding with SD or HD resolution
- Monitoring of encrypted programs when installing the CAM module
- Monitoring of IPTV channels
- MPEG Transport Stream analysis:
- Three-level analysis for compliance with the TR101290 requirements
- Real-time analysis
- Recording a transport stream to a file for further analysis
- Support of measurements in fiber optic cable network:
- Built-in optical receiver with a frequency range up to 2150MHz
- Support of all measurements from the optical input
- Measurement of optical signal power
- Operating in the wavelength range from 1100 to 1650 nm
- Replaceable FC and SC adapters of the input optical connector
- Power supply of external devices:
- Built-in remote feeding power supply from 5 to 24V
- Support for DiSEqC protocol level 2.1
- 5W power of remote feeding power supply
- Measurement of DC and AC voltage on the input RF connector
- Interface Support:
- USB 2.0 device for connecting the analyzer to a personal computer
- USB 2.0 host for connecting FLASH drives
- ETHERNET RJ45 10 / 100M for software updates, remote control and IPTV operation
- PCMCIA port for connecting a CAM module
- General specifications:
- Operating frequency range: 5 to 2150MHz
- Level measurement range: 20 to 120 dBμV
- Level measurement accuracy: ± 1.2dB
- Frequency step: 25 kHz
- Sweep time in the spectrum mode from 70 to 250 msec
- Built-in TFT color display 4.3 "with a resolution of 480x272 pixels
- Built-in speaker
- Operation from built-in battery and mains charger
- Battery life: 4 hours
- Analyzer weight: 1.5 kg
- Operating temperature range: -10 to +500С
|