RFOptic presents its new innovative controllable RF Over Fiber product line.

RFOptic’s palm size analog RFoF modules supporting up to 2.5GHz, are used to convert RF signals to optical signals to carry over long distances. The Tx unit uses an optical transmitter to convert RF to Optical signal. The Rx unit converts it back to RF signal. The two units are connected through the customer’s single mode fiber. All units can be monitored and managed remotely with RFOptic’s unique SNMP/HTML capability.

Key Features

• Next generation RFoF modules with significant performances improvement.
• Supports up to 0.5MHz –  2.5GHz.
• Better linearity, excellent gain flatness, and Tx, Rx and link gain control.
• Noise Figure down to 6 dB with LNA with MDS ~168 dB/Hz for very low incoming signals.
• Internal micro-controller and optical control are enabled by software.
• End-to-end diagnostics reduce installation and maintenance time, enabled by software.
• Remote Management by GUI installed on PC.
• Impedances of 50 Ohms and 75 Ohm.
• Bias-T (5V – up to 250 mA) – optional.

Configurations

• Bias-T for GPS applications
• Outdoor enclosure (unidirectional/bidirectional)
• 1U generic enclosure (4 units)
• 1U removable panel enclosure (4/8 units)

Applications

• Broadcast
• GPS
• Remote Antenna
• Satcom